AutoLisp Home

Home

A

T

T

M

A

P

A

T

T

M

A

P

A

T

T

M

A

P

A

T

T

M

A

P

A

T

T

M

A

P

A

T

T

M

A

P

A

T

T

M

A

P

A

T

T

M

A

P

AttMap

Attribute Mapping System

AttMap -  This program creates a attribute map from a drawing then lets you apply the attribute map to as many drawings as you want.

About:

AttMap Copyright 2002-2005 by JefferyPSanders.com.  All rights reserved.

Directions:

  The program starts by displaying the following dialog box:

  Begin the attribute mapping process by selecting the "Build an Attribute Map" button.  The application will prompt for you to select the source drawing that has the attribute values set properly:

Then lets you select a typical destination drawing.  (A drawing with attributes set incorrectly.)  This process is exactly the same at the one used above.  Next the application pulls up the Attribute Map Builder dialog box:

First select the attribute from the source drawing, then:

Select the attribute to map to in the destination drawing.  Press the "ADD" button to add it to the map.  The two selected attributes will dissappear from the list:

Continue this process until you get all of the attributes you want mapped.   Then press the "OKAY" button.  You will be prompted to save the attribute map to a file:

When the file is saved you will see the prompt below:

  Start the AttMap program again and select "Run the ATTMAP Program" button:

A dialog box will appear for you to select all of the drawings to apply the map to:

   Select all the drawings and press the "OKAY" button.  Then the program will prompt for the name of the map to use on these drawings.  Select a map and press the "Open" button.

  The program will write a script file and prompt you when it is ready to run:

When you press the "OK" button, the program will open each destination drawing, apply the attribute map, and save the drawing.  Although I don't know of any bugs in the program, please make a copy of the drawings before running the program.   

Ordering Information:

  To order this program please click the button above and pay $15.00 USD.  Please specify your email address.  Upon verification of payment, the program will be emailed to you.  Or if you prefer, send a check or money order made out to Jeffery P. Sanders, your email address, and the program name to :

Jeffery P Sanders
PO Box 512
Tioga, LA 71477.

If you have any questions about the program click here.

Back to top

AutoLisp Home

Home

All questions/complaints/suggestions should be sent to JefferyPSanders.com

Last Updated February 26th, 2005

Copyright 2002-2005 JefferyPSanders.com.  All rights reserved.